net_get - Copy a file from a network device to Ansible Controller¶

New in version 2.6.

Synopsis
- Requirements
Parameters
Notes
Examples
Status
- Support
- Author

Synopsis ¶

This module provides functionality to copy file from network device to ansible controller.

Requirements ¶

The below requirements are needed on the host that executes this module.

scp

Parameters ¶

Parameter	Choices/Defaults	Comments
dest	Default: [u'Same filename as specified in I(src). The path will be playbook root or role root directory if playbook is part of a role.']	Specifies the destination file. The path to the destination file can either be the full path on the Ansible control host or a relative path from the playbook or role root directory.
protocol	Choices: scp ← sftp	Protocol used to transfer file.
src required		Specifies the source file. The path to the source file can either be the full path on the network device or a relative path as per path supported by destination network device.

Notes ¶

Note

Some devices need specific configurations to be enabled before scp can work These configuration should be pre-configured before using this module e.g ios - ip scp server enable.
User privilege to do scp on network device should be pre-configured e.g. ios - need user privilege 15 by default for allowing scp.
Default destination of source file.

Examples ¶

- name: copy file from the network device to Ansible controller
  net_get:
    src: running_cfg_ios1.txt

- name: copy file from ios to common location at /tmp
  network_put:
    src: running_cfg_sw1.txt
    dest : /tmp/ios1.txt

Status ¶

This module is flagged as preview which means that it is not guaranteed to have a backwards compatible interface.

Support ¶

For more information about Red Hat’s support of this module, please refer to this Knowledge Base article

Author ¶

Deepak Agrawal (@dagrawal)

Hint

If you notice any issues in this documentation you can edit this document to improve it.