NAME | SYNOPSIS | DESCRIPTION | EXAMPLES | SEE ALSO | AUTHOR | COLOPHON |
IP-SR(8) Linux IP-SR(8)
ip-sr - IPv6 Segment Routing management
ip sr { COMMAND | help } ip sr hmac show ip sr hmac set KEYID ALGO ip sr tunsrc show ip sr tunsrc set ADDRESS
The ip sr command is used to configure IPv6 Segment Routing (SRv6) internal parameters. Those parameters include the mapping between an HMAC key ID and its associated hashing algorithm and secret, and the IPv6 address to use as source for encapsulated packets. The ip sr hmac set command prompts for a passphrase that will be used as the HMAC secret for the corresponding key ID. A blank passphrase removes the mapping. The currently supported algorithms for ALGO are sha1 and sha256. If the tunnel source is set to the address :: (which is the default), then an address of the egress interface will be selected. As this operation may hinder performances, it is recommended to set a non- default address.
Configure an HMAC mapping for key ID 42 and hashing algorithm SHA-256 # ip sr hmac set 42 sha256 Set the tunnel source address to 2001:db8::1 # ip sr tunsrc set 2001:db8::1
ip-route(8)
David Lebrun <david.lebrun@uclouvain.be>
This page is part of the iproute2 (utilities for controlling TCP/IP
networking and traffic) project. Information about the project can
be found at
⟨http://www.linuxfoundation.org/collaborate/workgroups/networking/iproute2⟩.
If you have a bug report for this manual page, send it to
netdev@vger.kernel.org, shemminger@osdl.org. This page was obtained
from the project's upstream Git repository
⟨git://git.kernel.org/pub/scm/linux/kernel/git/shemminger/iproute2.git⟩
on 2017-07-05. If you discover any rendering problems in this HTML
version of the page, or you believe there is a better or more up-to-
date source for the page, or you have corrections or improvements to
the information in this COLOPHON (which is not part of the original
manual page), send a mail to man-pages@man7.org
iproute2 14 Apr 2017 IP-SR(8)