STG-SYNC(1) StGit Manual STG-SYNC(1)
stg-sync - Synchronise patches with a branch or a series
stg sync [options] [--] [<patch1>] [<patch2>] [<patch3>..<patch4>]
For each of the specified patches perform a three-way merge with the
same patch in the specified branch or series. The command can be used
for keeping patches on several branches in sync. Note that the
operation may fail for some patches because of conflicts. The patches
in the series must apply cleanly.
-a, --all
Synchronise all the applied patches.
-B REF-BRANCH, --ref-branch REF-BRANCH
Syncronise patches with BRANCH.
-s SERIES, --series SERIES
Syncronise patches with SERIES.
Part of the StGit suite - see stg(1)
This page is part of the stgit (Stacked Git) project. Information
about the project can be found at ⟨http://www.procode.org/stgit/⟩.
If you have a bug report for this manual page, see
⟨http://www.procode.org/stgit/⟩. This page was obtained from the
project's upstream Git repository ⟨http://repo.or.cz/stgit.git⟩ on
2017-07-05. If you discover any rendering problems in this HTML ver‐
sion of the page, or you believe there is a better or more up-to-date
source for the page, or you have corrections or improvements to the
information in this COLOPHON (which is not part of the original man‐
ual page), send a mail to man-pages@man7.org
StGit 07/05/2017 STG-SYNC(1)
Pages that refer to this page: stg(1)