Skip Headers
Oracle® Database Reference
11g Release 2 (11.2)

Part Number E25513-03
Go to Documentation Home
Home
Go to Book List
Book List
Go to Table of Contents
Contents
Go to Index
Index
Go to Master Index
Master Index
Go to Feedback page
Contact Us

Go to previous page
Previous
Go to next page
Next
PDF · Mobi · ePub

DML_LOCKS

Property Description
Parameter type Integer
Default value Derived: 4 * TRANSACTIONS
Modifiable No
Range of values 20 to unlimited; a setting of 0 disables enqueues
Basic No
Oracle RAC You must set this parameter for every instance, and all instances must have positive values or all must be 0.

A DML lock is a lock obtained on a table that is undergoing a DML operation (insert, update, delete). DML_LOCKS specifies the maximum number of DML locks—one for each table modified in a transaction. The value should equal the grand total of locks on tables currently referenced by all users. For example, if three users are modifying data in one table, then three entries would be required. If three users are modifying data in two tables, then six entries would be required.

The default value assumes an average of four tables referenced for each transaction. For some systems, this value may not be enough.

Enqueues are shared memory structures that serialize access to database resources. If you set the value of DML_LOCKS to 0, enqueues are disabled and performance is slightly increased. However, you should be aware of the following restrictions when you set you DML_LOCKS to 0:

Oracle holds more locks during parallel DML than during serial execution. Therefore, if your database supports a lot of parallel DML, you may need to increase the value of this parameter.

See Also: